2-19. Grabhook Assembly
This task covers:
Pliers, Snap, Item 6, Appendix B
On work table
Punch, Item 8, Appendix B
Inspect. Refer to paragraph 2-8 for inspection procedures.
Repair. Repair of grabhook consists of replacing the keeper and the coupler.
Replace keeper (figure 2-7) (Refer to paragraph 2-20.).
Remove nut (1), and bolt (2).
Remove keeper (3) and spring (4).
Position spring (4) in new keeper (3) and onto grabhook (5).
(d) Slide bolt (2) through grabhook spring (4) and keeper (3) and tighten nut (1).
Figure 2-7. Grabhook Keeper Replacement