TM10-3950-672-24-2
Definition of Terms
The following is a list of guidelines for each procedure in the " Repair Sections" of the Troubleshooting and Repair
Manual. The procedure will be given first; followed by a definition of the step or steps involved.
Check - Examine a component or system for damage, excessive wear, accuracy, safety, or performance.
Inspect - Examine a component or dimension to make sure it meets the required specifications.
Test - Check or compare the performance of a component or system to established specifications.
Adjust - Complete the necessary steps to set or adjust the component, assemblies, or system in the required setting or
position.
Visually Inspect - Look for any obvious damage or problem.
Remove - Take off a component or assembly.
Disassemble - Take the component or assembly apart.
Repair - Restore a component or assembly to a serviceable condition within the established specifications.
Note: Only the easiest and simplest repairs will be made to a component or assembly. If a
component or assembly must be rebuilt; it must be replaced with a new or Cummins Diesel
ReCon , Inc. replacement or be rebuilt at a Cummins authorized repair location.
Replace - Install a new, properly rebuilt, or Cummins Diesel ReCon , Inc. component or assembly in place of one which
is removed.
Install - Place a component or assembly in the correct position.
Star Pattern Torque Sequence -
4-2