Figure 5-9. Reversing shaft assembly--exploded view.
d. Remove shims (12), (13) and (14). If the shims
e. Press reversing shaft hub (3) out of clutch
are in good condition, tie them together in the order in
housing (15), pressing on the end of the hub which is
which they were disassembled. If they are not in good
tapped for screws (9). Bearing (6) will remain in the
condition, measure and record their total thickness for
housing, but the inner race of bearing (17) will come off
use during assembly.
with hub (3).
f. Remove shims (19) and (20), grease fittings(21)