TM 5-3810-300-24 & P2
C. Position thrust washer and side gear in bevel gear and case half assembly.
D.
Place spider with pinions and thrust washers in
position.
E. Install component side gear and thrust washer.
F. Align mating marks, position component case half and draw assembly together with four bolts or cap screws
equally spaced.
G. Check assembly for free rotation of differential gears and correct if necessary.
H. Install remaining bolts and cap screws, tighten to the correct torque and lock wire.
I. If bearings are to be replaced, press squarely and firmly on differential case halves.
3.
Install Bearing Cups in Carrier Leg Bores.
A. Temporarily install the bearing cups, threaded adjusting rings where employed and bearing caps. Tighten the
cap screws to the proper torque.
B.
The bearing cups must be of a hand push fit in the
bores, otherwise the bores must be reworked with a
scraper or some emery cloth until a hand push fit is
obtained. Use a blued bearing cup as a gauge and
check the fits as work progresses.
4.
Install Differential and Gear Assembly.
A. After checking related parts, coat the differential bearing cones and cups specified rear axle lubricant.
4-252