TM 5-3810-300-24&P-3
121 Operating Mechanism,
the top of the fixture, with the follower pin resting on top
of the corresponding size plunger in the fixture.
2.
Drive the pin from the roller with a suitable drift.
Exercise caution in removing the cam follower body and
roller from the fixture as the roller pin is seated on a
spring-loaded plunger in the fixture.
3.
Before installing the new roller and pin, remove
lubricating oil or Cindol 1705 and wipe dry. Do not use
fuel oil. After washing the parts, lubricate the roller and
pin with Cindol 1705.
4.
Position the cam follower body in the groove of
the fixture, with the small plunger extending through the
roller pin hole in the lower leg of the follower body.
5.
Position the new cam roller in the cam follower
body. When released, the plunger will extend into the
roller bushing and align the roller with the cam follower
body.
Fig. 7 Testing Cam Follower Spring
6.
Start the new pin in the cam follower body, then
carefully tap it in until it is centered in the can follower
body.
7. Remove the cam follower from the fixture and
Fig. 8-Removing or Installing Cam Follower Roller
Page 45