TM 5-3810-302-10
start-up, it is advisable to use the COLD START switch (39, figure 4-1 ). See
CAUTION
AVOID OVERLOADING THE AIR INTAKE
WITH HIGHLY VOLATILE FLUID WHICH
COULD RESULT IN A MINOR EXPLOSION.
To start the engine, position the ignition switch (35, figure 4-1) to
1.
START and push the COLD START switch (39) for one or two seconds and
release. If the engine does not start within 30 seconds, allow the cranking
motor to cool two minutes and repeat the procedure.
ENGINE SHUTDOWN.
CAUTION
UNDER NORMAL CONDITIONS, DO NOT
SHUTDOWN ENGINE WITH A LOAD SUS-
PENDED IN THE AIR.
Position direction control lever (14, figure 4-1 ) to N (neutral).
1,
Push down on the park brake lever (22),
2,
NOTE
Turning the ignition switch (35) to OFF will
turn off all lights and indicators,
Turn ignition switch (35) to OFF,
3.
CRANE TRAVEL OPERATION
TRAVELING - GENERAL,
NOTE
The SCAMP was purposely wired to prevent
back- up alarm and back-up lights from oper-
ating in black-out mode. During normal oper-
ating conditions the Iights switch (43, figure
4-1) should be
left in STOP
LIGHT mode.