TM 5-3810-302-10
Transmission with Torque Converter.
8.
Lube Type - EO-10W
Lube Interval - Check daily with engine running and shift lever at N.
Change the filter every 250 hours
Drain every 500 hours or 12 months
Oil temperatures must be 150 to 180 degrees F (65.6 to 93.3
degrees C)
Lube Amount - Capacity of the torque converter, lines, and trans-
mission as a system is approximately 4.5 gallons (1 7.0 L)
Application - Through the fill pipe to the indicated level on the
dipstick
Drive Line Slip Joints and U-Joints.
9.
Lube Type - MPG
Lube Interval -50 hours
Lube Amount - Until grease extrudes
Application -1 grease fitting per joint (4 total each drive line)
10. Engine Cooling System.
Fluid Type -50-50 solution AFC and water
Interval - Check daily
Amount -3.1 gallons
Application - Fill at radiator cap
NOTE
For ambients 11 5-120F drain and replace
with pure water.
11. Outrigger Pivot Pins.
Lube Type - MPG
Lube Interval -25 hours
Lube Amount - Until grease extrudes
Application -1 fitting on outrigger arm pivot shaft
12. Outrigger Cylinder Pivot Pins.
Lube Type - MPG
Lube Interval -25 hours
Lube Amount - Until grease extrudes
Application -2 fittings on the upper cylinder common pivot shaft
1 fitting on the lower cylinder pivot shaft, each cylinder
6-7