ASSEMBLY - Continued
If removed, heat bearing cone (Figure 8, Item 1) to approximately 176°F (80°C) and install on ring gear carrier
(Figure 9, Item 2).
Figure 8. Planetary Wheel End Assembly.
END OF TASK
All parts must be cleaned before installation to prevent damage to gears.
Apply grease to hub seal lips and to hub seal runner.
Weight of hub and studs is approximately 79 lb (36 kg). Use adequate lifting equipment to lift
and support hub and studs. DO NOT lift over personnel or let personnel walk underneath
suspended load. Failure to follow this warning may result in injury or death to personnel.
Position hub (Figure 9, Item 1) onto pivot and spindle.
Install ring gear carrier assembly (Figure 9, Item 2).