To raise hoist cable pull MAIN hoist or AUX hoist
control lever back, toward you, and hold until hook or
load is raised to desired height.
PARKING AND STOWING
Never park the crane near holes or on
rocky or extremely soft surfaces. This
may cause the crane to overturn,
resulting in injury to personnel and
damage to the equipment.
After crane is parked, complete following:
If crane has been working on job site, retract and
lower boom over-the-front (travel position).
Set parking brake.
Before leaving the crane, ensure swing
lock and swing brake are both engaged.
Chock the wheels if parking crane overnight or
Switch AIR TEMP toggle switch to HI.
Pull HEATER ON/OFF switch to ON to begin the
automatic starting sequence.
Set AIR TEMP toggle switch to HI (raises
temperature) or LO (lowers temperature).
Depress HEATER ON/OFF switch.
immediately, since heater has a purge
cycle. The blower will run until all fuel in
the burner is consumed and heat
exchanger cools sufficiently to open the
flame switch. When this occurs, the
blower motor will stop.