TRANSMISSION SHIFT HYDRAULIC LINES, CARRIER
TOOLS: General mechanics tool kit: automotive (5180-00-177-7033)
Loctite 545 (Item 13, Appendix C)
Preformed packings as required
Disconnect ground cable at shunt. (Refer to page 8-109.)
replace all hydraulic lines.
REMOVE HYDRAULIC LINE.
Tag and disconnect both ends of hydraulic line.
Remove line and preformed packing. Note
routing for ease in installation.
Remove fittings and preformed packing as
necessary. Discard preformed packing.
Inspect all parts for damage and replace as
INSTALL HYDRAULIC LINE.
Coat threads with Loctite 545 and preformed
packing with clean hydraulic fluid prior to
Install fittings and new preformed packing.
Route hydraulic line and connect both ends with
new preformed packing. Tighten securely.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
START ENGINE AND CHECK TRANSMISSION
SHIFT FUNCTIONS. CHECK FOR LEAKS.
(REFER TO TM 5-3810-306-10.)
END OF TASK