SpecIal Steel Sleeve.
Bushing Installation Tool.
Seal Removal Tool.
The special steel sleeve is used to insert the drive shaft
through the lip seal without damage and can be made
from bar stock. For the P315 use a 1" dia. x 3-1/8" bar;
for the P330 use a 1-1/8" or 1-1/4" dia. x 4-5/8" bar; for
the P350 use a 1-3/8" dia. x 4-5/8" bar ; for the P365 use
The seal removal tool can easily be made from an old
a 1-3/8" dia. x 4-5/8" bar. Refer to the drawing titled
screwdriver. Heat the tip and bend as shown in the fig-
ure titled Seal Removal Tool. Grind the tip to fit the notch
Special Steel Sleeve and the accompanying chart for
the dimensions needed to manufacture the tool.
behind the shaft seal.