LUBRICANT n INTERVAL
INTERVAL n LUBRICANT
Planetary Pinion Gear
GAA
(2 fittings (These
CW11 Intermediate Hoist and
points are removed
Pinion Shaft Gears
when equipment is be
GAA
Safety Pawl Pin
Ing utilized as clam-
(3 fittings)
shell or dragline)
GAA
Planetary Pinions
Drum Bearing
GAA
(2 fittings)
Drum Shaft Outboard
GAA
End Bearing
GAA
Drum Shaft Outboard
End Bearing
Dipper Trip Lever
GAA
Assembly
GAA
Planetary Spider
(Located beneath floor
GAA
Boom Hoist Drum Bear-
panel) (Necessary only
ing
when equipment is being
utilized as shovel)
GAA
Drum Shaft Bearing
Drum Shaft Bearing
GAA
GAA
Clutch Drum Bearing
Planetary Gear and
CW11
Plug
Pinions
(Remove plugs and in-
(Clean and coat)
sert fitting to lubricate)
GAA
Chain Tightener
HDO Crowd Chain
(Clean and Coat)
FOLD
FOLD
-KEY-
LUBRICANTS
CAPACITY
EXPECTED TEMPERATURES
INTERVALS
Above +32 F
+40 F to -10 F
0 F to -65 F
HDO-OIL, Engine Heavy Duty
Chain Case
14 qts
HDO 30
HDO 10
OES
Oil Can Points
Intervals
OES-Oil, Engine, Sub-zero
given are
GO-LUBRICATING OIL, Gear
In hours of
Power Take-off
8 qts
GO 90
GO 90
GOS
normal
Jack Shaft Pedestal Case
24 qts
operation
GOS-LUBRICATING OIL, Gear, Sub-zero
CW-11-B LUBRICATING OIL, Exposed Gear
ALL TEMPERATURES
GAA-GREASE, Automotive and Artillery
NOTES:
1.
FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD
TEMPERATURES BELOW - 10 F. Remove lubricants prescribed in the
Symbols and applicable Specification numbers.
HDO MIL-L-45199
GOS MIL-L-10324
key for temperatures above - 10 F. Relubricate with lubricants specified In
GO MIL-L-2105
GAA MIL-L-10924
the key for temperatures below - 1 F.
OES MIL-L-10295
CW-11B VV-L-751
2. OIL CAN POINTS. Every 10 service hours lubricate all linkage, pins and
Copy of this Lubrication Order will remain with the equipment at all times,
instructions contained herein are mandatory.
clevices with HDO.
BY ORDER OF THE SECRETARY OF THE ARMY.
3. CHAIN CASE BREATHER. Every 250 service hours remove breather
W. C. WESTMORELAND
General, United States Army,
cap and clean In approved cleaning SOLVENT. Dry, reoil and re-install.
Chief of Staff
4. TRAVELING. When traveling, lubricate the following points every 2
OFFICIAL
service hours, swing gear bushing, vertical propel shaft and propel gear
KENNETH G. WICKHAM
bushing.
Major General, United States Army,
The Adjutant General.
LO 5-3810-206-12-4 DISTRIBUTION To be distributed in accordance with DA Form, 12-25, (qty rqr block no. 349) Section II, Operator's Maintenance requirements for Crane Shovels, Crawlers 40 Ton
GPO 822-248
