1 Pin (2)
12 Pin
2 Rod
13 Plug(2)
3 Pawl
14 Pin
4 Spring
15 Locknut
5 Washer
16 Lever assy
6 Lever
17 Lever assy
7 Pin
18 Ball
8 Lever
19 Bearing
9 Pin
20 Spring
10 Link
21 Pin
11 Lever assy
22 Plug (3)
Figure 4-10. Transmission lever linkage, exploded view.
c. Cleaning and Inspection.
(5) Drain transmission by removing filler pipe.
(6) Place suitable lift cradle under transmission oil
(1) Clean all parts.
pan to support weight of transmission.
(2) Inspect all parts for cracks, distortion
(7) Remove upper capscrews that secure
excessive wear, or other defects. Replace defective
transmission to converter housing and insert pilot studs
parts as necessary.
d. Reassembly. Reassemble lever linkage show in
in their place.
(8) Remove lower capscrews that secure
figure 4-10.
transmission to converter housing.
e. Installation.
(9) Insure that cradle alines transmission with
(1) Install lever linkage as shown in figure 4-'
converter housing then pull transmission away from
(2) Install front and rear servos (para 4-6 4-8.
converter housing.
Transmission
b. Disassembly.
a. Removal.
(1) Remove transmission lever linkage (para 4-7).
(1) Remove reversing gearbox (para 4-2).
(2) Remove transmission shafts and related parts
(2) Disconnect vacuum line and wires from
shown in figure 4-11.
vacuum control switch.
(3) Disassemble transmission shafts and related
(3) Remove neutral start switch (TM 10-3950-
parts shown in figure 4-12.
203-20).
(4) Disconnect transmission control linkage
4-13
