Figure 3-110. Planetary clutch band and brake band, removal and installation.
Inspect springs for deformation, strength, or other
(2) Remove the four capscrews (fig. 3-111)
defect. Inspect mounting hardware for burs, wear,
and washers from lagging.
stripped threads, or elongated holes.
(3) Refer to figure 3-112 and remove sleeve
(3) Repair by replacing defective mounting
nut (sheer washer) by use of special tool (table 3-1).
hardware, defective springs, and clutch or brake bands
(4) Secure lifting device to lagging halves,
when lining is worn to within 1/16 inch of rivet heads.
remove the two nuts, washers and bolts that hold halves
together, then lift lagging off drum.
3-131. Drum Lagging and Sleeve Nut (Shear
(5) Remove remaining laggings in a similar
Washer)
manner.
a. Removal and Installation.
(6) Install in reverse order.
(1) Remove cable from drum (para 3-43).
a. Cleaning, Inspection, and Repair
3-122
