ME 3810-201.35/410
1 Jaw (2 rqr)
22
Nut (14 rqr)
43
Link
2 Spring
23
Spider
44
Spring
3 Flatwasher (2 rqr)
24
Bolt, shoulder
46
Pin (2 rqr)
5 Rivet (12 rqr)
26
Nuts (6 rqr)
47
Cotterpin (2 rqr)
6 Clutch shoe (2 rqr)
27
Stud (6 rqr)
48
Nut
7 Lining (2 rqr)
28
Eyebolt ( rqr)
49
Sleeve bearing
8 Cotterpin (2 rqr)
29
Spring (S rqr)
50
Pin
9 Nut (2 rqr)
30
Bracket (4 rqr)
51
Capscrew (2 rqr)
10 Lockwasher (2 rqr)
31
Spring (4 rqr)
52
Capscrew
11 Flatwasher (2 rqr)
32
Capscrew (4 rqr)
53
Plug
12 Lever
33
Bracket
54
Bumper
13 Nut (2 rqr)
34
Lockwasher
56
Nut
14 Lockwasher (4 rqr)
35
Capscrew
56
Cotterpin
15 Washer (2 rqr)
36
Capscrew
57
Washer
16 Capscrew (2 rqr)
37
Capscrew (4 rqr)
58
Washer
17 Keeper plate (2 rqr)
38
Lining (2 rqr)
59
Pin (4 rqr)
18 Adjusting sleeve (2 rqr)
39
Rivet
60
Cotterpin
19 Clutch shoe (2 rqr)
40
Trunnion (2 rqr)
61
Pin
20 Capscrew (2 rqr)
41
Brakeshoe adjusting bolt (2 rqr)
62
Drum
21 Lockwasher (4 rqr)
42
Nut (2 rqr)
Figure 4-10. Hoisting, digging, and auxiliary clutches, exploded view
Section IX. VERTICAL INTERMEDIATE IDLER SHAFT
(2) Working from rear of revolving frame and
4-19. General
over the jackshaft, remove the two rear sections of
The vertical intermediate idler shaft spur gear meshes
horizontal gear train cover (TM 5-3810-201-12).
with spur gear on top of intermediate swing shaft and
(3) From top, remove lockwire (12, fig. 4-11),
swing gear on vertical swing shaft.
two capscrews (11), and dirt guard (10).
(4) Lift washer (4, fig. 4-12) from top of shaft (7).
4-20. Vertical Intermediate Idler Shaft
(5) Support weight of shaft (7, fig. 4-12) from
beneath revolving frame, by using wood blocks, or jack,
a. Removal and Disassembly.
then remove two capscrews (10), lockwashers (9) and
keeper plate (8) from shaft (7).
(1) Rotate revolving frame to a position where
idler shaft will pass through the crossmember of crawler
(6) Lower shaft slowly to the ground.
carbody, then stop engine.
4-17
