CHAPTER 1
INTRODUCTION
Section I. GENERAL
Engineer Maintenance Center, Corps of Engineers,
1. Scope
ATTN: MCSDM, P. O. Box 119, Columbus 16, Ohio.
a. These instructions are published for the use of
Direct communication is authorized.
field and depot maintenance personnel maintaining the
e. Report unsatisfactory equipment performance
Quickway Model M-200 Crane-Shovel. They provide
and suggestions for equipment improvement as
information on the maintenance of the equipment which
specified in AR 700-38.
is beyond the scope of the tools, equipment, personnel,
or supplies normally available to using organizations.
2. Record and Report Forms
b. Appendix I contains a list of applicable
publications. The Maintenance Allocation Chart is in
For record and report forms applicable to field
TM 53810-207-20. Field and depot maintenance repair
and depot maintenance, refer to TM 38-750.
parts are listed in TM 5-3810-20735P.
c. Numbers in parentheses on illustrations indicate
Note. Applicable forms, excluding
quantity. Numbers preceding nomenclature callouts on
standard Form 46 which is carried by
illustrations indicate the preferred maintenance
the operator, shall be kept in a
sequence.
canvas bag mounted on the
d. Report all deficiencies in this manual on DA
equipment.
Form 2028. Submit recommendations for changes,
additions, or deletions to The Commanding General,
Military Construction Supply Agency/U.
S.
Army
Section II. DESCRIPTION AND DATA
b. Crane Engine.
3. Description
Engine ........................................ Gasoline
A general description of the crane-shovel, the
Manufacturer ............................ Continental Motors Corp.
location and description of the identification and
Model ....................................... BS-415
instruction plates, and information on the difference in
Serial numbers ......................... 20-001 through 20-500
models are contained in TM 5-3810-207-10. A more
Horsepower ............................. 110 at 1800 rpm (revolu-
detailed description of the components is contained in
tions per minute)
TM 5-3810-207-20.
The repair and maintenance
Number of cylinders ................ 6
instructions are described in appropriate sections of this
Cooling .................................... Liquid
manual.
Compression at cranking ......... Cold 100 lb (pounds) hot
speed 125 lb
4. Tabulated Data
Bore ......................................... 414 in. (inch)
a. Craneshovel.
Stroke ...................................... 4 in.
Manufacturer .................Quickway Truck Shovel Co.
Displacement .......................... 415 cu.
in.
(cubic
Model number ..............M-200
inches)
Designated use .............Back hoe, crane, clamshell,
Governed speed ...................... 1800 rpm
dragline, shovel and pile,
Oil pressure at 1800 rpm ......... 40-50 lb
driver
Minimum oil pressure (at 7 lb
idle)
Firing order ............................... 1-5-3-6-2-4
TAGO 5030A
4
