b. Installation.
beam assembly in the reverse of the instruction on figure
Install the equalizing
beam
assembly as illustrated on figure 120.
Section III. CARRIER REAR, REAR AXLE DIFFERENTIAL ASSEMBLIES
418. General
a. Removal.
The forward rear and rear axles are top mounted
double-reduction drive units. The through shafts of the
(1) Disconnect the propeller shafts (TM 5-
hypoid gear drive units are supported at the forward end
3810-207-20).
by tapered roller bearings and at the rear end by a
straight roller bearing. Pinion bearing preload is adjusted
(2) Remove the rear airbrake lines (TM 5-
and maintained by a hardened precision spacer between
3810-207-20).
the inner and the outer tapered bearings. The front
rear through-shaft is splined on both ends while the rear
(3) Drain the two axle housing (TM 5-3810-
one is not splined on both ends.
207-20).
419. Carrier Rear, Rear Axle Differential Assemblies
(4) Disconnect the torque rods (par. 411).
Removal and Disassembly
Figure 118. Torque rod assembly, removal and installation.
TAGO 5030A
192
