MEC 3810-227-15/57 (2)
1
Speedometer
19
Starter push switch
37
Choke data plate
2
Speedometer drive shaft
20
Utility outlet
38
Park data plate
3
21
Control cable
39
Declutch data plate
4
Tachometer drive shaft
22
Choke control
40
Front axle data plate
5
Oil pressure indicator
23
Panel light data plate
41
Receptacle any.
6
Air pressure indicator
24
Lights data plate
42
Information plate, front axle
7
Batt-gen. voltage indicator
25
Outlet data plate
43
Screw
8
Fuel level indicator
26
Oil data plate
44
Screw
9
Heat indicator
27
Turn data plate
45
Screw
10
Indicator light (high heat)
28
High beam data plate
46
Screw, drive
11
Indicator light (low oil press.)
29
Air beam data plate
47
Screw
12
Indicator light (turn signals)
30
Fuel data plate
48
Knockout plug
13
Panel lights
81
Water data plate
49
Mounting panel
14
Panel light (high beam)
82
Starter data plate
50
Throttle control
15
Heater switch
38
Heater data plate
51
Hazard warning plate
16
Main light switch
34
Throttle data plate
52
Indicator light turn signal
17
Rheostat
35
Ignition data plate
18
Ignition switch
36
Wiper data plate
C-Instrument panel assembly.
Figure 57. continued.
b. Cleaning and Inspection.
(1) Turn lens counterclockwise to remove and
remove lamp.
(1) Clean the panel light assembly with a
(2) Remove the high beam indicator light
cloth dampened with an approved
assembly as instructed on figure 57.
cleaning solvent and dry thoroughly.
b. Cleaning and Inspection.
(2) Inspect the panel light assembly for
proper operation. Replace a defective
(1) Clean the high beam indicator light assembly
panel light assembly.
with a cloth dampened with an approved
c. Installation.
cleaning solvent and dry thoroughly.
(2) Inspect the high beam indicator light
(1) Install the panel light assembly as
assembly for proper operation. Replace a
illustrated on figure 57.
defective high beam indicator light assembly.
(2) Install the lamp and install cover.
c. Installation.
111. High Boom Indicator Light Assembly
(1) Install the high beam indicator light assembly
as illustrated on figure 57.
a. Removal.
(2) Install the lamp and install lens.
AGO 6819A
101
