TM 5-3810-288-12
CHAPTER 6
INSTALLATION AND OPERATING INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF MATERIEL
6-1. Inspecting and servicing the Equipment
6-3. Installation or Setting Up Instructions
Refer to paragraph 2-1 for inspection and services to be
performed on the equipment upon receipt of materiel.
to be performed on arrival at the work site.
6-2. Installation of Separately Packed
Components
Refer to paragraph 2-2 for installation instructions of the
separately packed carrier components.
Section II. MOVEMENT TO A NEW WORK SITE
6-4. Dismantling for Movement
6-5. Reinstallation after Movement
Refer to paragraphs 2-11 and 2-12 for instructions on the
Refer to paragraphs 2-11 and 2-12 and reinstall the
dismantling of the equipment before movement to a new
equipment after movement to a new work
work site.
Kite.
Section III. CONTROLS AND INSTRUCTIONS
any position other than blackout.
6-6. General
(b) Outside lamp selector switch. This lever has
This section describes the various controls and
five positions, as follows:
instruments and provides the operator/crew with
1. Blackout drive
sufficient information to insure proper operation of the
2. Blackout marker
Model M320T truck crane carrier.
3. Off
67. Controls and Instruments
4. Stop lights
a. General. The carrier operating controls and
5. Service drive
each control is given below. The controls are listed in
The desired combination of lights may be
selected by the operator by lifting lock lever A and turning
Note. The operator must study the information in this
switch B.
section, and be thoroughly familiar with location and
Panel light selector switch. This switch selects
function of each control, before attempting to operate the
the type of panel lighting, in four positions, as follows:
machine.
1. Park
2. Off
b. Controls.
3. Dim
4. Bright
(1) Master tight switch. The master light control
switch has three handles. They are:
(2) Cab dome light switch. This switch controls
the cab dome lights.
(a) Lock lever. This lever prevents the outside
(3) Oil temperature warning light. This
lamp selector lever (lever B) from moving, except into
the blackout position.
This pre-vents accidental
actuation of lights under blackout conditions. Move this
lever upward and hold to allow lever B to be turned to
6-1
