TM 5-3810-288-12
7-18.
Tie Rod and Drag Link Service
Clean the area around the tie rod and drag link ends to
prevent the entry of dirt into the tie rod and drag link
ends. Lubricate the tie rods and drag link in accordance
with the lubricant order.
7-19.
Transmission Inspection and Service
a. Inspection. Inspect the main transmission and
drop box for leaks or other damage. A wet area usually
indicates a leak, and should be traced to the source of
the leak. Report all leaks or dam-age to Direct Support
Maintenance. Check the oil level by removing the oil
level plug. The oil should be just up to the oil level
opening.
b. Service. Add oil of the type listed in the
lubrication order as required.
7-20.
Transfer Case Inspection and Service
a. Inspection. Inspect the transfer case for leaks or
other damage. A wet area usually indicates a leak, and
should be traced to the source of the leak. Report all
leaks or damage to Direct Support Maintenance. Check
the oil level by removing the cap on the standpipe. The
oil should be just below the end of the standpipe.
b. Service. Add oil as necessary, of the type listed
Figure 7-10. Fuel tank service. (Sheet 2 of 2)
in the lubrication order.
7-21.
Propeller Shaft Service
Lubricate the universal joints in accordance with the
lubricant order.
7-22.
Rear Axle Inspection
The inspection of the rear axles is the same as the front
axle. Refer to paragraph 7-17 and inspect the rear
axles.
7-23. DifferentialInspection Inspect the area around
the front and rear differentials for oil leaks and damage.
Report all leaks and damage to General Support
Maintenance. Check the oil levels by removing the oil
level plug. The oil level should be just up to the oil level
opening.
Report low oil level to Organizational
Maintenance
7-24.
Wheel Inspection
