TM 5-3810-288-12
APPENDIX B
BASIC ISSUE ITEMS LIST
Section I. INTRODUCTION
Code
Explanation
B-1.
Scope
X Parts and assemblies which are not procured or
This appendix lists items which accompany the Model
stocked and the mortality of which normally is
M320T Truck Crane or are required for installation,
below that of the applicable end item or
operation, or operator's maintenance. Repair parts and
component. The failure of such part or assembly
special tools assigned maintenance code "C" in the -20P,
should result in retirement of the end item from
Organizational Maintenance Repair Parts and Special
the supply system.
Tools List, may be stocked at the operator level of
X1 Repair parts which are not procured or
maintenance when authorized by the Unit Commander.
stocked. The requirement of such items will be
filled by use of the next higher assembly or
component.
B-2.
General
X2 Repair part which are not stocked. The indicated
This Basic Issue Items List is divided into the following
maintenance category requiring such repair parts
sections:
will
attempt
to
obtain
them
through
a. Basic Issue Items--Section II. A list of items
cannibalization. Where such repair parts are not
which accompany the Model M320T Truck Crane and
obtainable through cannibalization, requirements
are required by the operator/crew for installation,
will be requisitioned, with accompanying
operation, or maintenance
justification, through normal supply channels.
b. Maintenance and Operating Supplies--
C Repair parts authorized for local procurement.
Where such repair parts are not obtainable from
Section II. A listing of maintenance and operating
local procurement, requirements will be
supplies required for initial operation.
requisitioned through normal supply channels
accompanied by a supporting statement of non-
B-3.
Explanation of Columns
availability from local procurement.
The following provides an explanation of columns in the
G Major assemblies that are procured with PEMA
tabular list of Basic Issue Items, Section II.
funds for initial issue only as exchange
a. Source, Maintenance, and Recoverability
assemblies at DSU and GSU level.
These assemblies will not be stocked above GS
Codes (SMR):
and DS level or returned to depot supply levels.
(1) Source code, indicates the selection
(2) Maintenance code indicates the lowest
status and source for the listed item. Source codes are:
category of maintenance authorized to install the listed
Code
Explanation
item. The maintenance level code is:
P
Repair part which are stocked in or
Code
Explanation
supplied from the GSA/DSA, or Army
supply system and authorized for us at
C--- Operator/crew
indicated maintenance category.
(3) Recoverability code, indicates whether
P2
Repair parts which are procured and
unserviceable items should be returned for recovery or
stocked for insurance purposes because
salvage.
Items not coded are expendable.
the combat or military essentially of the
Recoverability codes are:
end item dictates that a minimum quantity
be available in the supply system.
Code
Explanation
M
Repair parts which are not procured or
R Repair parts and assemblies which are
stocked, but are be manufactured in
economically repairable at DSU and GSU
indicated maintenance levels
activities and are normally furnished by supply on
A
Assemblies which are not procured or
an exchange bass.
stocked as such, but are made up of two
S Repair parts and assemblies which are
or more units. Such component units
economically repairable at DSU and GSU
carry individual stock numbers and
activities and which normally are furnished by
descriptions, are procured and stocked
supply on an exchange basis. When items are
separately and can be assembled to form
determined by a GUS to be uneconomically
the required assembly at indicated
maintenance categories .
repairable they will be evacuated to a depot
for evaluation and analysis before final
disposition.
B-1
