SECTION II TM 5-3810-293-34P (1) (2) (3) (4) (5) (6) ITEM SMR PART NO CODE FSCM NUMBER DESCRIPTION AND USABLE ON CODES (UOC) QTY GROUP 0105 VALVES,  CAMSHAFTS,  AND TIMING SYSTEM. FIG.  9 CAMSHAFT. 1 PFHZZ 72582 5116476 SEAL, PLAIN ENCASED  CAM AND........................... 2 BALANCER OIL PART OF KIT P/N 5199793.............. 2 PAHZZ    24617 5150087 NUT PLAIN, HEXAGON................... ........................... 4 3 PFHZZ 72582 5121109 PULLEY, GROOVE FRONT BALANCE....... ............... 2 4 PFHZZ 72582 5121071 SPACER, SLEEVE CAM AND BALANCER ................ 2 SHAFT PULLEY .......................................................... 5 PFHZZ 72582 5134388 DEFLECTCR, DIRT AND  CAM AND.......................... 2 BALANCER SHAFT OIL .............................................. 6 PFHZZ 96906 MS35756-34 KEY, WOODRUFF  FRONT BALANCE......... ............. 4 7 PFHZZ 72582 5197944 BEARING SET, SLEEVE  CAM AND .......................... 1 BALANCER SHAFT, STANDARD INSIDE AND ......... OUTSIDE DIAMETER ................................................. 7 PFHZZ 72582 5198983 BEARING SET, SLEEVE  CAM AND BALANCE ........ 1 SHAFTISTANDARD INSIDE DIAMETER,................... .010 INCH OVERSIZE OUTSIDE DIAMETER ............ 7 PFHZZ 72582 5197945 BEARING SET1SLEEVE  CAM AND .......................... 1 BALANCER SHAFT,.010 INCH UNDERSIZE ............. INSIDE DIAMETER, STANDARD OUTSIDE .............. DIAMETER .................................................................. 7 PFHZZ 72582 5197946 BEARING  CAM AND BALANCER SHAFT................. 1 .010 INCH UNDERSIZE INSIDE DIAMETERT............ STANDARD OUTSIDE DIAMETER ............................ 8 PFHHH   72582 5199397 CAMSHAFT ASSEMBLY  RIGHT BANK..................... 1 8 PFHHH   72582 5199396 CAMSHAFT, ENGINE  LEFT BANK............................ 1 9 PFHZZ 72582 5151277 .PIN STRAIGHT, HEADLE............... ........................... 4 10 PFHZZ 72582 5121077 SPACER, SLEEVE  CAMSHAFT GEAR....... .............. 2 11 PFHZZ 72582 5116198 BEARING UNIT SAMSHA  CAM AND......................... 2 BALANCER SHAFT END BEARING THRUST ........... 12 PAHZZ    72582 9409028 BOLT, SELF-LOCKING  CAM AND BALANCER ........ 4 SHAFT END BEARING THRUST................................ 13 PFHZZ 72582 5107072 GEAR, ENGINE CAM SHA RIGHT HAND .................. 1 13 PFHZZ 72582 5107073 CAM AND BALANCE GEA LEFT HAND HELIX.......... 1 14 PFHZZ 72582 5172734 PLATE, RETAINING, SHA CAM AND......................... 2 BALANCER SHAFT GEAR NUT 15 PAHZZ    96906 MS35338-8 WASHER, LOCK  RETAINER ..................................... 4 16 PAHZZ    96906 MS90727-58 SCREW, CAP, HEXAGON H. ..................................... 4 END OF FIGURE 9-1