TM 5-3810-295-20P
quantity of the item in the breakout shown on the
illustration and note the illustration figure and item
illustration figure, which is prepared for a functional
number of the repair part.
(4) Fourth. Using the Repair Parts Listing,
group, subfunctional group, or an assembly. A "V"
appearing in this column in lieu of a quantity indicates no
find the figure and item number noted on the illustration.
b. When National stock number or part
specific quantity is applicable, (e.g. shims, spacers, etc.).
number is known.
(1) First. Using the Index of National
4.
Special Information
Stock Numbers and Part Numbers, find the pertinent
a. Detailed manufacturing instructions for
National stock number or part number. This index is in
items source coded to be manufactured or fabricated are
ascending NIIN sequence followed by a list of part
found in TM 53810-295-34. Bulk materials required to
numbers in ascending alphanumeric sequence, cross-
manufacture items are listed in the Bulk Materials Group
referenced to the illustration figure number and item
of this manual.
number.
b. Detailed assembly instructions for items
(2) Second. After finding the figure and
source coded to be assembled are found in TM 5-3810-
item number, locate the figure and item number in the
295-34. Assembly components are listed immediately
repair parts list.
following the item to be assembled.
c. Repair parts kits and gasket sets appear as
the last entries in the repair parts listing for the figure in
6.
Abbreviations
which its parts are listed as repair parts or are listed at
DEG........................... Degree
the end of the repair parts listing for the last figure
DIA ............................ Diameter
containing parts of the kit.
FT .............................. Feet
d. The following publications pertain to the
GA ............................. Gauge
crane and its components:
GR ............................. Grade
TM 5-3810-295-12
Operator's and Organizational
HD ............................. Head
Maintenance Manual
HEX ........................... Hexagon
LO 5-3810-295-12-
Lubrication Order
HEX HD ..................... Hexagon head
1, -2 and-3
ID ............................... Inside diameter
IN ............................... Inch
The illustrations in this manual are identical to those
LG.............................. Long
published in TM 5-3810-295-34P. Only those parts
MFD........................... Manufactured
assigned the third position SMR maintenance code "C"
MIL............................. Military
or "O" are listed in the tabular listing; therefore there may
MTG........................... Mounting
be a break in the item number sequence.
Only
NO ............................. Number
illustrations containing organizational authorized items
NOM .......................... Nominal
appear in this manual.
NPT ........................... National Pipe Thread
5.
How to Locate Repair Parts
NPTF ......................... National Pipe Thread Fine
NSN ........................... National Stock Number
a. When National stock number or part
OD ............................. Outside diameter
number is Unknown.
P/N ............................ Part Number
(1) First. Using the table of contents,
PT .............................. Point
determine the functional group within which the repair
RPM........................... Revolutions per minute
part belongs. This is necessary since illustrations are
SPEC......................... Specification
prepared for functional groups, and listings are divided
THK ........................... Thick
into the same groups.
V ................................ As required
(2) Second. Find the illustration covering
W/ .............................. With
X ................................ By
the functional group to which the repair part belongs.
(3) Third. Identify the repair part on the
ix
