TM 5-3810-300-24 & P2
C. Press the pinion shaft through the forward pinion bearing cone and drive gear.
D. Lift out the forward pinion bearing cone and two spacers. Remove the drive gear and pinion. (Remove the drive
gear
spacer from the pinion shaft not used on all models).
E. Remove the forward pinion bearing cup with suitable puller.
F. Remove the rear pinion bearing cup with a suitable puller and remove the cup spacer and shim pack. (Spacer not
used on all models).
G. Wire the shim pack together to facilitate reassembly.
NOTE
THIS SHIM PACK CONTROLS THE DEPTH OF PINION IN RELATION TO THE HYPOID GEAR AND
IT MAY BE INCREASED OR DECREASED TO CHANGE THE TOOTH CONTACT AT TIME OF
REASSEMBLY.
H. If necessary to remove the rear pinion bearing,
use a suitable puller that bears against bearing
inner race or press off with a fixture that
supports inner race.
7. Disassemble Inter-Axle (3rd) Differential Assembly.
A. Fold out the tabs on rear bearing snap ring
retainer and remove snap ring with snap ring
pliers. Remove snap ring retainer.
4-240