TM 5-3810-300-24 & P2
C. Position thrust washer and side gear in bevel gear and case half assembly.
D. Place spider with pinions and thrust washers in position.
E. Install component side gear and thrust washer.
F.
Align mating marks, position component case half
and draw assembly together with four bolts or cap
screws equally spaced.
G. Check assembly for free rotation of differential gears and correct if necessary.
H. Install remaining bolts and cap screws, tighten to the correct torque. If a drilled or castellated fastener is
employed, install a lockwire.
I. If bearings are to be replaced, press squarely and firmly on differential case halves.
4.
Install Bearing Cups in Carrier Leg Bores.
A. Temporarily install the bearing cups. threaded adjusting rings where employed and bearing caps. Tighten the
cap screws to the proper torque.
B.
The bearing cups must be of a hand push fit in the
bores, otherwise the bores must be reworked with a
scraper or some emery cloth until a hand push fit is
obtained. Use a blued bearing cup as a gauge and
check the fits as work progresses. Once the cups
fit properly, remove the bearing caps.
B.
4-281
