TM 5-3810-300-24 & P2
F. Remove brake assembly from steering knuckle if brake service is required.
G. Remove tie rod end nut and disassemble cross
tube assembly from cross tube arm.
H. Remove cross tube arm nut, and steering arm nut and disassemble cross tube arm and steering arm from
knuckle.
NOTE
IT IS NOT NECESSARY TO REMOVE CROSS TUBE ARM OR STEERING ARM FROM KNUCKLE
UNLESS SERVICE IS NECESSARY.
J.
Remove steering knuckle cap capscrews, caps
and gaskets from top and bottom of knuckle.
Some models may employ an integral gasket in
the lower seal and thrust bearing.
4-292