TM 5-3810-300-24&P-3
Variable-Speed Limiting Speed Governor 2.7.1.3
7. Thread the idle speed adjusting lock nut on the
after the governor adjustments (Section 14.3.3) have
threaded end of the high-speed spring plunger
been performed.
approximately 1/2 ".
8. Screw the adjusting shaft into the adjusting shaft
Install Governor
retainer all the way in as shown in Fig. 1.
9. Install the adjusting retainer and shaft onto the high-
Install the governor as outlined in Section 2.7.1, then
speed spring plunger. Turn down the adjusting retainer
connect the manual control flexible shaft to the governor
against the idle speed adjusting lock nut.
spring housing (Fig. 1).
10. Install the adjusting coupling and spring housing
Adjust the governor as outlined in Section 14.3.3.
Page 224