TM 5-3810-300-24&P-3
13.2.1 Run-In Instructions
specified for the particular engine. This speed may be
F. INSPECTION AFTER FINAL RUN-IN
either higher or lower than the maximum speed used
during the Basic Run-In. This will ordinarily require a
After the Final Run-In and before the Engine Test Report
governor adjustment.
is completed, a final inspection must be made. This
inspection will provide final assurance that the engine is
All information required in Section "E", Final Run-In, of
in proper working order. During this inspection, the
the Engine Test Report should be determined and filled
engine is also made ready for any brief delay in delivery
in. After the prescribed time for the Final Run-In has
or installation which may occur. This is accomplished by
elapsed, remove the load from the dynamometer aud
rustproofing the fuel system as outlined in Section 15.3
reduce the engine speed gradually to idle speed and
and adding a rust inhibitor into the cooling system (refer
then stop the engine. The Final Run-In is complete.
to Section 13.3). The lubricating oil filters should also be
changed.
Page 369
