TM 5-3810-307-10
Accessory Tools and Components
The accessory tools and components are initially provided with the Pile Driver System and
located in two tool boxes that are housed in the shipping/storage container. Identification and
weight data is stenciled on the sides of the tool boxes. The accessory tools and components
include rigging and safety equipment, shipping/storage equipment, accessories and adapters,
ground servicing tools, special tools, consumable materials such as lubricants, seal kits and
spare filters, and miscellaneous spare parts.
The rigging and safety equipment include the following:
One trip safety lever cord (3/8" x 100 ft (10 mm x 30.5 m))
One piston lifting eyebolt
Two 96-inch (2.44 m) wire rope lifting slings
Two 89-inch (2.26 m) wire rope lifting slings
Two 72-inch (1.8 m) wire rope lifting slings
Two nylon lifting slings
One H-type pile lifting sling (30-inch (76 cm))
Two H-type pile chain lifting slings with hooks
Two one-inch (2.5 cm) shackles
Two 7/8-inch (2.2 cm) shackle
Eight 3/4-inch (1.9 cm) shackles
Two ground-release shackles
One temporary hydraulic hose retainer chain (5/16 x 90-inch (0.8 x 229 cm))
Four 4x4-inch (10 x 10 cm) wood blocks
1/2 x 48-inch (1.3 cm x 1.22 m) long wire cable
5/8 x 96-inch (1.6 cm x 2.44 m) long wire cable and 5/8-inch (1.6 cm) clamps for
rigging the square (concrete) and sheet pile adapters
The shipping/storage equipment is red in color and used to protect and secure the impact
hammer for storage and/or transportation. The equipment includes the catch ring weather cap
and securing strap, intake/exhaust port weather cap, piston transportation pin and clip, and trip
transport bolt.
The accessories and adapters are used to drive different size piles (wood other than 18-inch
(45.7 cm and steel H-beam), pre-cast concrete, or sheet piles. The adapters include the
following:
10-inch (25.4cm), 12-inch (30.5 cm), and 16-inch (40.6 cm) guide plates
18-inch (45.7 cm) square (concrete) pile adapter
Sheet pile adapter
Plywood template for the 18-inch (45.7 cm) square (concrete) pile adapter
The guide plates are bolted onto the lower drive housing of the direct drive assembly and
replace the standard 18-inch (45.7 cm) guide plate. The size of the guide plate indicates the
inside diameter. The square (concrete) pile adapter and sheet pile adapter are installed in the
direct drive assembly and secured via cables and clamps to the adapter holes located at the
bottom of the lower cylinder. The adapter holes are the lower holes directly below the impact
hammer lifting lugs. Weight data is stenciled on the sides of the pile adapters. The plywood
template for the 18-inch (45.7 cm) square (concrete) pile adapter can be used by operating
personnel to fabricate a cushion to prevent damage to the square concrete piles during
operation.
The ground servicing tools are used to add fuel and oil to the fuel and lubrication systems and to
drain the waste fuel drip tank on the impact hammer. The ground fueling tools include a ground
fueling hand pump and ground fueling hose and quick connect fitting. The ground oiling tools
Change 1 H-17
