TM 5-3810-307-24-1-1
Repair
Replace all worn, damaged, or defective parts.
Installation
a.
Install windshield washer reservoir as follows:
(1)
Position spacers (41, Figure 2-1-3) and washer reservoir (40) on mounting studs and secure with
washers (39), lockwashers (38), and nuts (37).
(2)
Connect hose (36) and electrical connector to reservoir pump.
b.
Assemble drive linkage and bracket as necessary:
(1)
Install pin (35) in the top hole of pivot shaft (31) and secure with lockwasher (34) and nut (33).
(2)
Install pin (35) of pivot shaft (31) in hole nearest cutout of linking arm (32) and secure with c-clip
(30).
(3)
Install drive arm (29) on linking arm (32) with c-clip (28).
(4)
Position drive linkage in bracket (27) and secure pivot shaft (31) with lockwashers (26) and screws
(25).
c.
Install wiper motor as follows:
(1)
Insert shaft of wiper motor (24) into hole of bracket (27) while positioning drive arm (29) on shaft so
that arm is parallel with motor housing. Secure drive arm (29) on motor shaft with washer (21) and
locknut (20). Torque locknut (20) 150-180 lbs-in. (17-20 Nm).
NOTE
Ensure drive arm (29) remains parallel with motor housing when tightening
locknut (20). If arm moves, cycle motor (using 24 vdc) to position arm prior to
further installation.
(2)
Secure wiper motor (24) to bracket (27) with lockwashers (23) and capscrews (24). Ensure motor
ground wire is installed under right side capscrew.
(3)
Position seal (18) and plate (17) on outside of cab. Insert capscrews (15) with lockwashers (16)
through plate (17), seal (18), and wall of cab.
(4)
Position lockwashers (19) on capscrews (15) and secure bracket (27) with wiper motor (24) in cab
by tightening capscrews (15).
(5)
Connect electrical wires for wiper motor and remove tags.
(6)
Install lockwasher (14), washer (13), and nut (12) on pivot shaft (31), and then position boot (11) and
drive gear (10) on pivot shaft.
2-1-17
