TM 5-3810-307-24-1-1
(14) Connect lever of bracket assembly (96) to pivot arm (108) with nut (85).
(15) Install overheat switch (83) in baffle (78) with star washers (82) and screws (81).
(16) Install electrical lead (79) and grommet (80) in cover (75).
(17) Position baffle (78) under cover (75), connect electrical lead to overheat switch (83), and secure
baffle (78) to cover (75) with star washers (77) and screws (76).
(18) Install cover (75) on bracket (88) with star washers (74) and screws (73). Route and connect
electrical leads for overheat switch (83) to terminal board (111) and remove tags.
(19) Install mount plate (72) on bracket (88) with star washers (71) and screws (70).
(20) Apply thread sealant to threads of setscrews (68), then install fan (69) on shaft of motor (50) as
marked during removal with setscrews (68) ensuring setscrews engage flats on motor shaft.
(21) Install bracket (67) on motor (50) as marked during removal with washer (66) and screw (65).
NOTE
If replacing motor and blower as an assembly skip to step (27), otherwise
continue with next step.
(22) Install gasket (64), washer (63), and blower housing (62) on motor (50) with washer (61), washers
(60), lockwashers (59), and nuts (58).
(23) Install fan wheel (57) on shaft of motor (50) and secure with spring clip (part of fan wheel hub).
(24) Install stationary wheel (56) on blower housing (62) with screws (55).
(25) Install spacer (54) and fan wheel (53) on shaft of motor (50). Secure fan wheel (53) with spring clip
(part of fan wheel hub).
(26) Install blower cover (52) on blower housing (62) with clamp (51).
(27) Install motor (50) with blower assembly on mount plate (72) with washers (49) and screws (48).
(28) Connect electrical leads for motor (50) and remove tags.
(29) Install air hose (47) to blower cover (52) and bottom of case (89) with clamps (46).
(30) Install ignition pack (45) on bracket at bottom of case (89) with star washers (44) and screws (43).
(31) Install hose (42), glow plug (41), gasket (40), and igniter (39) on burner head (37).
(32) Install gasket (38) and burner head (37) on heat exchanger (84) with pressure pads (36) and screws
(35).
(33) Connect electrical leads to glow plug (41) and igniter (39). Remove tags.
(34) Install air hose (34) on burner head (37) and blower housing (62) with clamps (33).
(35) Install carburetor assembly (31) on burner head (37) with screws (30). Connect electrical leads for
carburetor assembly (31) and remove tags.
2-1-33
