TM 5-3810-307-24-1-1
1.
Install the caps and o-rings on the cylinder
5.
Install the cylinder rod with piston into the
barrel, refer to Figure 2-8-25.
cylinder barrel with a slight twisting motion.
2.
Install the seal and wear ring onto the outside
6.
Install the cylinder head onto the cylinder
of the piston on the cylinder rod.
barrel.
WARNING
3.
Install the wear ring, deep Z rod seal, and
wiper ring onto the inside of the cylinder head and
Do not use air pressure to cycle or
the backup ring and low temperature o-ring onto the
pressurize the cylinder. Use only a
outside of the cylinder head.
source of controlled hydraulic oil
pressure.
4.
Lubricate all components freely with clean
hydraulic oil.
7.
Pressurize and cycle the cylinder.
Check for proper operation and any
leakage.
2-8-62 C-1
