TM 5-3810-307-24-2-2
Once the gear is properly started on the camshaft, insert
the torque arm into the screw press and, using a wrench
with the screw press, install the camshaft gear.
NOTE
Do not exceed 135.6 Nm [100 ft-lb] of torque
while installing the gear. Do not use an
impact wrench with this or any other
Cummins special tool. It can damage the
engine parts or the tool.
While turning the screw, the effort required should
increase steadily until the gear seats against the
camshaft shoulder.
When the gear is properly installed, the gear is in
contact with the shoulder on the camshaft.
Disassemble the camshaft gear installation tool and
remove the camshaft retainer.
1-37 C-1