TM 10-3950-672-24-2
12mm
Remove the capscrews, connecting rod cap and
Caution: Use care so that the cylinder bore or
connecting rod are not damaged.
Use a hammer handle or similar object to push the
piston and connecting rod through the cylinder bore.
Put the assemblies in a rack for disassembly later.
Inspect the rod journals for deep scratches, indications
of overheating and other damage.
Cylinder Bores - De-Glaze
Note: New piston rings may not seat in glazed cylinder
bores.
De-glazing gives the bore the correct surface finish
required to seat the rings. The size of the bore is not
changed by proper deglazing.
5-223