TM 10-3950-672-24-2
This illustration shows the result of the drill speed too
fast or the vertical stroke is too slow.
Note: Vertical strokes must be smooth continuous
passes along the full length of the bore.
Inspect the bore after 10 strokes.
Use a strong solution of hot water and laundry detergent
to clean the bores.
Since a relatively large volume of water will be used to
rinse the bores, position the vehicle over or close to a
floor drain.
Caution: Clean the cylinder bores immediately after
deglazing.
Rinse the bores until the detergent is removed and blow
the block dry with shop air.
5-226