LO 5-3810-294-12
*See Note 16 for lubricant specification number.
NOTES:
1.
FOR
OPERATION
OF
EQUIPMENT
IN
and hinges, yoke pins and clevises, springs, fasteners
PROTRACTED COLD TEMPERATURES BELOW -15F
and all exposed adjusting threads with OE/HDO, except
(-260C).
Remove lubricants prescribed in Key for
those adjusting threads coming in Contact with
temperatures above -150F (-260C). Relubricate with
excavated material.
lubricants specified in Key for temperatures below -150F
(-260C). If OEA lubricant is required to meet the
3. CRANKCASE OIL LEVEL HOT OR COLD CHECK
temperature ranges prescribed in the Key, OEA lubricant
(CARRIER AND CRANE). Cold engine, oil level should
is to be used in place of OE/HDO-10 lubricant for all
be at high mark on dipstick. Hot engine, oil level must be
temperature ranges where OE/HDO-10 is specified in
between high and low marks on dipstick (allow to set 5
the Key.
minutes before checking).
2.
OIL CAN POINTS. Each 50 hours lubricate
4. CRANKCASE OIL (CARRIER AND CRANE). Oil is
accelerator shaft, governor linkage, air brake treadle
to be changed each 100 hours. Drain when lubricant is
roller and hinge pin, clutch pedal linkage, door latches
warm.
CARD 11 OF 12
