TM 10-1670-251-12&P
c. Reaching Ground Level.
(1)
Upon reaching the ground, adopt a squatting posi-
tion, pull the safety pin from the governor
snaphook, then stand up.
(2)
Disconnect the governor snaphook from the V-ring
on the personnel harness.
(3)
If the lowering device is to be drawn back Into the
helicopter, remove the personnel harness and
attach the governor snaphook to the V-ring of the
personnel harness.
(4)
If the lowering device is not to be drawn back into
the helicopter, signal for the rope snaphook to be
released from the anchor point within the
helicopter.
Section V. OPERATION WHEN USED WITH
UH-1 HELICOPTER
Paragraph
Page
2-13
Installation Procedure ....................
2-40
2-14
Lowering Procedure........................
2-43
2-39
