TM 10-1670-251-12&P
3-13.
Governor Assembly (cont).
(b) Cut a 15-inch length of type II, nylon cord,
remove core cords, and sear ends.
(c) Cut a 5-inch length of 0.0B0-inch diameter
steel wire. Form safety pin (3).
(d) Pull cord halfway through loop in safety pin
(3).
(e) Tie cord to safety pin (3) with a square knot.
(f)
At a point 4 1/2 inch from first square knot,
tie a second square knot.
(g) Tie cord around snaphook loop with square
knot and tie overhand knots In each running
end.
d.
Replace. Replace an unserviceable/unrepair-
able governor assembly with one from stock.
3-26
