Table 2-1. Preventive Maintenance Checks and Services-Continued

Table 2-1. Preventive Maintenance Checks and Services-Continued - TM-10-1670-298-20P_26

TM-10-1670-298-20P Container Delivery System A-7A Cargo Sling Manual
Page Navigation
21

TM 10-1670-298-20&P Table 2-1. Preventive Maintenance Checks and Services-Continued Location of Not Mission Item No. Interval Item to Procedure Capable If: Check/Service 11 After Capsule, Cargo, CTU-2/A (Cont.) f. M5 Cartridge WARNING Actuated Release EXPLOSIVE HAZARD DO NOT attempt to disassemble the M5 cartridge actuated release assembly, which has been sealed at the manufacturing source. Serious injury or death could occur for failure to observe this warning Conduct external visual inspection to ensure lack of obvious defects. g. Fins Inspect for damaged rivets and cracks or distortion of plates and angles Replace the entire assembly if badly warped. 12 After Strap Check for loose or broken stitches, cut, Connectors, 60- worn, or frayed webbing, and foreign and 120-Inches material. (152 400- and 304.800 cm) Long 13 Monthly Quick Release Service by soaking assembly In Assembly tetrachloroethylene. SECTION IV. MAINTENANCE PROCEDURES 2.8 GENERAL REPAIR INSTRUCTIONS. a. Repair Limitations. Only those repairs prescribed in the Maintenance Allocation Chart (MAC) (Appendix B) are authorized. Repair cost limitations to preclude uneconomical repair of the airdrop items contained In this publication will conform to the requirements of TB 43-0002-43. b. Searing and Waxing. CAUTION Cotton tape, webbing, or cord will not be seared. Permanent damage to the material will result (1) Searing. The ends of nylon tape, webbing, and cord lengths may be prepared by heat searing which is performed by pressing the material's raw end against a hot metal surface until the nylon has melted sufficiently. Avoid forming a sharp edge or lumped effect on the melted end. 2-9

Privacy Statement
Press Release
Contact