c. Cleaning and Inspection.
(5) Discard and replace all lockwashers, oil
(1) Clean all parts.
seals, and gaskets.
(2) Inspect bearings, cups, and cones
(6) Remove burs and nicks from machined
scoring and wear. Replace defective parts.
and ground surfaces.
(3) Inspect first reduction bevel and sec
(7) Replace pinion bushings as required.
reduction spur gear for wear and damage. Rep
d. Reassembly. Reassemble differential in reverse
defective gears as a set.
order of disassembly.
(4) Inspect case halves, thrust washers, spider
e. Installation. Install front wheel drive shafts
trunnions, and differential pinion and side gear
and gears (para 3-21).
excessive wear and other defects. Replace an
these defective parts in sets.
3-33
