b. Cleaning and Inspection.
(3) Install starter (TM 10-3950-203-20).
(4) Install torque converter (para 4-9).
(1) Clean flywheel.
(2) Inspect for cracks, broken ring gear teeth and
5-2. Flywheel Housing
other defects. Replace defective parts a necessary.
a. Removal
c. Installation.
(1) Remove flywheel (para 5-1).
(1) Heat ring gear and install if applicable.
(2) Remove flywheel housing as illustrated in
(2) Install flywheel and check run-out a shown in
figure 5-2.
figure 5-1. In the event run-out exceed 0.008 inch,
replace flywheel.
1 Screw (2)
3 Washer (5)
2 Screw (3)
4 Housing
Figure 5-2. Flywheel housing exploded view.
b. Cleaning and Inspection.
c. InstalcatiIns.tallation
l . on
(1) Clean flywheel housing.
(1) Refer to figure 5-2 and install
(2) Inspect for cracks or other
flywheel housing in reverse of removal
defects. Replace defective flywheel
procedure.
housing .
(2) Install flywheel (para 5-1).
Section II. TIMING GEAR COVER AND GEARS
(2) Remove crankshaft pulley using
5-3. Timing Gear Cover
gear puller.
a. Removal.
3) Refer to figure 5-3 and remove
(1) Remove governor (para 3-12)
timing gear cover.
5-3
