TM 10-3950-206-12
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF MATERIAL
4-1. Service Upon Receipt of Material
Section II. MOVEMENT TO A NEW WORKSITE
4-2. Movement to a New Worksite
Section III. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
the Warehouse Crane.
4-3. Tools and Equipment
4-5. Maintenance Repair Parts
Tools, equipment, and repair parts issued with or
Repair parts and equipment are listed and illustrated in
authorized for the Pettibone Model 10FM Warehouse
the Repair Parts and Special Tools List, TM 10-3950-
Crane are listed in the basic issue items list, appendix B.
206-20P, covering organizational maintenance for this
4-4. Special Tools and Equipment
equipment.
No special tools or equipment are required for the
performance of organizational maintenance functions of
Section IV. LUBRICATION INSTRUCTIONS
4-6. General
Caution: Do not over tighten the bolt as
This section contains organizational level lubrication
damage to the gasket may occur.
instructions, which are supplemental to, and may not be
g. Operate engine at idle speed for one minute.
specifically covered in the lubrication order. Refer to
Check oil level. Add oil as required. Operate at
governed speed for 10 minutes. Check for oil leaks
instructions.
around filter cover.
4-7. Engine Oil Filter Service
4-8. Transmission Service
Refer to figure 3-1, and service the engine oil filter as
a. Refer to figure 4-1 and service the transmission
follows:
oil filter, sump, and strainer as instructed. Consult
a. Loosen the top bolt and remove the cover
lubrication order for proper lubricant.
assembly.
b.
After servicing transmission operate for
b. Remove the cover gasket and discard.
approximately five minutes.
Check for leaks and
c. Lift out the used filter element and discard.
maintain proper oil level.
d. With clean rag or toweling clean the inside of the
4-9. Drive Shaft Service
filter shell.
Refer to figure 4-2 and service the drive shaft in
e. Position new filter element in the shell and a new
accordance with lubrication order.
cover gasket in the cover.
f. Position the cover over the shell and secure with
the top bolt.
4-1