TM 10-3950-206-12
Figure 4-2. Drive shaft service points.
Figure 4-1. Transmission service instructions..
4-10. Drive Axle Service
a. Remove drain plug (fig. 4-3) and drain lubricant
from axle housing.
Figure 4-3. Drive axle service points.
Note. More thorough drainage will occur if
axle is warm.
b. Servicing procedure for the hydraulic system
b. Clean the magnetic drain plug and reinstall.
filter is identical to that of the transmission oil filter,
c. Remove fill plug (fig. 4-3) and fill with lubricant
specified on lubrication order.
c. Remove the small and large covers (fig. 4-5A)
d. Reinstall fin plug and check for leaks.
and clean any sludge from bottom of tank.
4-11. Rear Steering Axle Service
d. The sump filter, assessable through the larger
Refer to figure 4-4, and service the rear steering axle in
opening may be removed and cleaned by back- flushing
accordance with lubrication order.
oil through the filter. Reinstall after cleaning.
4-12. Hydraulic System Service
e. Remove breather and fill cap (fig. 4-5A). Clean
a. Remove drain plug (fig. 4-5B) and drain entire
in an approved cleaning solvent and dry.
hydraulic system.
4-2
