TM 10-3950-206-12
1.
Pedal assembly
7. Locknut (2)
13.
Clevis (2)
2.
Capscrew (4)
8. Rod
14.
Locknut (2)
3.
Lockwasher (4)
9. Pivot Arm
15.
Rod
4.
Bearing (2)
10. Cotter pin (2)
16.
Clevis pin (2)
5.
Clevis Pin (2)
11. Pin
17.
Washer
6.
Clevis (2)
12. Cotter pin (2)
18.
Spring
Figure 4-28. Accelerator pedal and linkage, exploded view.
(2) Remove bowl (5), gasket (4), element (3),
4-48. Fuel Tank
from cover (2).
a. Removal.
(3) Clean bowl and cover with a cloth
dampened in an approved cleaning solvent.
(4) Install a new gasket and element on the
screen (8).
cover. Position bowl and bail; tighten bail nut.
(5) Check for leaks around bowl gasket.
and lift cover plate from over tank filler neck.
b. Removal.
(4) Remove drain plug (12) and allow tank to
drain.
(2) Disconnect fuel pump line from filter.
(5) Disconnect wire lead from level sending
(3) Disconnect filter from reducing bushing.
unit (5). Remove five screws (4), washers (R) sending
c. Installation. Reverse procedures in b above.
unit (5) and gasket (6).
4-35