TM 10-3950-206-12
ME 3950-206-12/4-29
1. Hose
2. Tube assy
3. Elbow
4. Elbow
5. Control valve
ME 3950-206-12/4-30
Figure 4-29. Pollution control valve and piping, exploded
1. Fuel line
view.
2. Lockwasher
3. Nut
(6) Disconnect hose (22) from adapter (20).
4. Capscrew
(7) Remove swivel (20), strainer (19), close
5. Clip
nipple (18), bushing (17), street ell (16), and gate valve
6. Elbow
(15).
7. Tube nut
(8) Remove four capscrews (11), lockwashers
8. Lockwasher
(10), and flat washers (9).
9. Nut
(9) With suitable hoist lift fuel tank (2) from
10. Fuel pump
well in frame.
11. Gasket
b. Cleaning and Inspection.
12. Stud (2)
(1) Clean cap and strainer in an approved
13. Lockwasher (2)
cleaning solvent; dry with compressed air.
14. Nut (2)
(2) Inspect strainer for distortion, dents or
15. Elbow
other damage. Replace if defective.
16. Elbow
(3) Inspect tank and fittings for damage;
17. Clamp (2)
replace as required.
18. Hose
c. Installation. Reverse the procedure for removal.
Figure 4-30. Fuel pump and lines, exploded view.
4-36
