TM 5-3810-201-20P
Section I
INTRODUCTION
1. Scope
3. Explanation of Columns
This manual contains a list of repair parts and
The following provides an explanation of columns
special
tools,
required for
the performance of
in the tabular lists.
a. Source, Maintenance and Recoverability Codes.
organizational maintenance of the crane shovel.
(1) Source Code indicates the selection status
and source for the listed item. Source codes are:
2. General
Code
Explanation
This repair parts and special tools list is divided into
three principal sections and a Federal stock number
P
Applied to repair parts which are stocked in or
index.
supplied from DSA/GSA or Army supply
system, and authorized for use at indicated
(PLA), is a consolidated listing of repair parts
maintenance categories.
quantitatively allocated for initial stockage at the
M
Applied to repair parts which are not procured or
organizational level. This is a mandatory minimum
stocked but are to be manufactured at
stockage allowance.
indicated maintenance categories.
A
Applied to assemblies which are not pro cured or
stocked as such but are made up of two or
parts authorized for the performance of maintenance at
more units, each of which carry individual
the organizational level.
stock numbers and descriptions and are
procured and stocked and can be
Equipment List, is a list of special tools, test and support
assembled
by
units
at
indicated
equipment authorized for the performance of
maintenance categories.
maintenance at the organizational level.
X
Applied to parts and assemblies which are not
procured or stocked, the mortality of which is
Manufacturer's Part Number Index, is an index of
normally below that of the applicable end
item, and the failure of which should result in
Federal Stock Numbers and manufacturer's part
retirement of the end item from the supply
numbers to page and manufacturer's codes.
system.
X1
Applied to repair parts which are not procured or
common to all models.
stocked, the requirement for which will be
supplied by use of the next higher assembly
model 855BG2 non-winterized only.
or components.
X2
Applied to repair parts which are not stocked.
model 855BG2 winterized only.
The
indicated
maintenance
category
requiring such repair parts will attempt to
obtain them through cannibalization; if not
model 855BG3 non-winterized only.
obtainable through cannibalization, such
repair parts will be requisitioned with
supporting justification through normal
supply channels.
C
Applied to repair parts authorized for local
procurements. If not obtainable from
v
