TM 5-3810-206-35
1
Spacer (2 rqr)
11
Lug (2 rqr)
21
Lockwasher (12 rqr)
2
Spacer (2 rqr)
12
Flatwasher (4 rqr)
22
Nut (12 rqr)
3
S haft
13
Cotterpin (2 rqr)
23
Front leg, LH
4
Truss
14
Castelated nut (2 rqr)
24
Cotterpin (8 rqr)
5
Brace, horizontal (2 rqr)
15
Setscrew
25
Pin (2 rqr)
6
Brace, diagonal
16
Sheave guard
26
Pin (2 rqr)
7
Bolt (12 rqr)
17
Bushing
27
Front leg, R
8
Cotterpin (2 rqr)
18
Sheave
28
Keeper plate
9
Pin (2 rqr)
19
Fitting
29
Screw (2 rqr)
10
Tension member (2 rqr)
20
Washer (3 rqr)
Figure 2-3. Gantry, exploded view.
e. Remove rear canopy, rear doors, and rear cab
m.
Remove two bolts (5, fig. 2-2), lockwashers (7),
panels (TM 5-3810-206-12).
and nuts (6) from front of engine and mounting base.
(14), and bolts (16) from rear of engine and rear engine
support.
Caution: Disconnect power cables
o. Remove two nuts (11), bevel washers (10), and
from battery and engine.
capscrews (12) from power take-off (2) and power take-
g. Tag and disconnect all electrical leads from
off support (9).
engine (TM 5-3810-206-12).
p. Position lifting sling on engine in manner to
h. Remove radiator (TM 5-3810-206-12).
avoid damage of engine accessories or components.
i. Disconnect shutdown and throttle control linkage
q. Use a suitable lifting device and remove the
from engine (TM 5-3810-206-12).
engine from revolving frame. Be careful, and assure that
j. Disconnect fuel lines from fuel pump (TM 5-
engine clears all obstructions of equipment on the
3810-206-12).
revolving frame.
k. Disconnect clutch lever linkage from power take-
r. Install engine by reversing procedures given in a
off (TM 5-3810-206-12).
through q above.
l. Remove drive chain case and drive chain from
power take-off (TM 5-3810-206-12).
2-9