TM 5-3810-207-20/TO 36C23-3-37-12 CHAPTER 1 INTRODUCTION Section I.  GENERAL 1.  Scope a. These  instructions  are  published  for  the  use  of the   personnel   to   whom   the   Quickway   Model   M-200 Crane-shovel   and   the   M-1200   KW   Dart   Carrier   are issued.      They   provide   information   on   organizational maintenance   of   the   equipment,   its   accessories,   and auxiliaries.    This  manual  also  includes  instructions  for shipment and limited storage. b. Appendix    I    contains    a    list    of    publications applicable   to   this   manual.      Appendix   II   contains   the maintenance    allocation    chart.        The    organizational maintenance  repair  parts  and  special  tools  lists  are  in TM 5-3810-207-20P. c. Numbers in parentheses on illustrations indicate quantity.  Numbers preceding nomenclature callouts on illustrations indicate the preferred maintenance sequence. d. Report all deficiencies in this manual on DA Form 2028.  Submit recommendations for changes, additions, or deletions   to   commanding   officer,   U.S.      Army   Engineer Maintenance Center, Corps of Engineers, ATTN:  EMCDM- S,    P.    O.    Box    119,    Columbus    16,    Ohio.        Direct communication is authorized. e.    Report  unsatisfactory  equipment  performance and suggestions for equipment improvement as specified in AR 750-5. 2.  Record and Report Forms For record and report forms applicable to organizational maintenance, refer to TM 38-750. Note. Applicable forms, excluding Standard Form 46 which is carried by the operator, shall be kept in a canvas bag mounted on the equipment. Section II.  DESCRIPTION AND DATA 3.  Description TM 5-3810-207-10 provides a general description of the Quickway Crane-shovel. Specific and detailed descriptions of the components of the Quickway Crane- shovel   are   provided   in   the   applicable   maintenance paragraphs of this manual. 4.  Identification and Tabulated Data a. Identification. (1) Crane-shovel. (a) Starter   identification      plate.      This plate  is  attached  to  the  starter  on the  left-rear  side  of  the  engine  and gives the name of the manufacturer, model, serial number,  voltage,  and  amperage  of the starter. (b) Generator identification plate.  This plate is attached to the generator on the left- front side of the engine.  The plate states the  name  of  the  manufacturer,  model, serial  number,  voltage,  and  amperage of the generator. (c) Clutch    identification    plate.        This plate    is    attached    to    the    clutch assembly   on   the   top   side   and   is located  at  the  rear  of  the  engine. This  plate  names  the  manufacturer and gives the model, serial number, and type of clutch assembly. (d) Fuel pump identification plate.  This plate  is  attached  to  the  side  of  the fuel  pump  and  is  mounted  on  the top of the clutch housing at the 3