TM 5-3810-207-20/TO 36C23-3-37-12
rear of the engine. The plate gives
manufacturer's name and model
number only.
(e)
Heater identification plate. This
plate is attached to the top side of
the
heater
and
gives
the
manufacturer's name, model, serial
number, and size of the heater.
The heater is mounted on the floor
of the revolving frame at the left-
rear side of the engine..
(f)
Ignition unit distributor identification
plate. This plate is mounted on the
ignition
unit
and
states
the
manufacturer's model and serial
number. The ignition unit is
mounted on the top center of the
engine.
(g)
Windshield
wiper
motor
identification plate. This plate is
located on the windshield wiper
body and states the voltage and the
manufacturer's
number.
The
windshield wiper is mounted on the
left-upper side of the operator's cab.
(h)
Generator
regulator
identification
plate. This plate is mounted on the
generator regulator cover. It gives
the manufacturer's name, model,
ordnance number, serial number,
specification
number,
voltage,
amperage, type of ground, and
military standard number. The
generator regulator is mounted on
top of the engine.
(2) Carrier.
(a)
Engine governor identification plate.
This plate is mounted on the side of
the engine governor housing. It lists
the manufacturer's name, model,
and serial number.
(b)
Air compressor identification plate.
This plate is mounted on the left
side
of
the
air
compressor
crankcase.
It
lists
the
manufacturer's name, compressor
plate number, type, and serial
number. The air compressor is
mounted on the right side of the
engine.
(c)
Generator
regulator
identification
plate. This plate is mounted on the
generator regulator cover. It gives
the manufacturer's name, model,
ordnance number, serial number,
specification
number,
voltage,
amperage, type of ground, and
military standard number. The
generator regulator is mounted on
the carrier engine hood.
(d)
Generator identification plate. This
plate is mounted on the side of the
generator. It gives the name of the
manufacturer,
model,
serial
number, voltage, and amperage.
The generator is located on the left
side of the engine.
(e)
Starter identification plate. This
plate is attached to the starter. This
plate gives the name of the
manufacturer,
model,
serial
number, voltage, and the amperage
of the starter.
(f)
Ignition unit identification plate. This
plate is attached to the ignition unit.
It gives the manufacturer's model
and serial number. The ignition unit
is mounted on the left side of the
engine on top of the auxiliary drive
housing.
(g)
Personnel heater identification
plate. This plate is attached to the
side of the heater and gives the
manufacturer's name, model and
serial
numbers,
voltage,
and
capacity output. This heater is
mounted on the outside rear of the
operator's cab.
(h)
Engine heater identification plate.
This plate is attached to the heater
door on the side of the heater and
gives the manufacturer's name,
model and serial numbers, voltage,
and capacity output. This heater is
mounted on the rear of the engine
compartment.
(i)
Windshield
wiper
motor
identification plate. This plate is
located on the windshield wiper
motor body
4
![](//www.tpub.com/assessment.jpg)