b. Inspection and Repair. Inspect all parts for
60. Crane Engine Generator Assembly Removal and
excessive wear or other damage. Repair or replace all
Disassembly
defective parts. Refer to TM 5-764 for armature and
a. Removal. Remove the crane engine generator
field coil tests.
assembly from the crane engine assembly (TM 5-3810-
207-20).
62. Crane Engine Generator Assembly Reassembly
b. Disassembly. Disassemble the crane engine
and Installation
generator assembly in the numerical sequence as
illustrated on figure 7.
a. Reassembly. Reassemble the crane engine
generator assembly in the reverse of the numerical
61.
Crane Engine Generator Assembly Cleaning,
sequence as illustrated on figure 7.
Inspection, and Repair
assembly on the crane engine assembly (TM 5-3810-
a. Cleaning.
Clean all parts with an approved
207-20).
cleaning solvent.
Section V. CRANE INSTRUMENT PANEL AND WIRING HARNESS
65. Crane Instrument Panel and Wiring Harness
63. General
Cleaning and Inspection
The crane instrument panel is located on the right side
of the crane cab and contains the necessary gages,
a. Cleaning. Clean the instrument panel with an
instruments, and wiring for proper operation of the crane
approved cleaning solvent and dry thoroughly. Clean
engine.
the wiring harness with a lint-free dry cloth.
b. Inspection. Inspect all parts for excessive wear
64.
Crane Instruments Panel and Wiring Harness
or damage. Replace all damaged or defective parts.
Removal
66. Crane Instrument Panel and Wiring Harness
a. Remove the light switches (TM 5-3810-207-20).
Installation
b. Remove the water temperature light, dashlight,
and low oil pressure light (TM 5-3810-207-20).
a. Install the crane instrument panel and wiring
c. Remove the engine starter switch (TM 5-3810-
harness as illustrated on figure 8.
207-20).
d. Remove the horn button, choke control, and
oil pressure gage, and fuel gage (TM 5-3810-207-20).
power receptacle (TM 5-3810-207-20).
c. Install the horn button, choke control, and power
receptacle (TM 5-3810-207-20).
gage, oil pressure gage, and fuel gage (TM 5-3810-207-
d. Install the engine starter (TM 5-3810-207-20).
20).
e. Install the water temperature light, dashlight,
f. Remove the instrument panel and wiring
and low oil pressure light (TM 5-3810-207-20).
harness as instructed on figure 8.
f. Install the light switches (TM 5-3810-207-20).
Section VI. CRANE ENGINE STARTER ASSEMBLY
67. General
The crane engine starter assembly is a heavy duty type
volts at 30 maximum amperes with no load, and
with over-running clutch-type drive. The starter turns at
develops 20 foot pounds torque, drawing 6.6 volts at
6,000 rpm, drawing 23.4
200 maximum amperes when locked. The starting
motor has four poles using eight
TAGO 5080A
37
